Service Release Version:	2.8.2.0.21

Products:	Intel(R) NetStructure(tm) 7140 Traffic Director  
		Intel(R) NetStructure(tm) 7140E Traffic Director-Export  
		Intel(R) NetStructure(tm) 7145 Traffic Director  
		Intel(R) NetStructure(tm) 7145E Traffic Director-Export 
		Intel(R) NetStructure(tm) 7170 Traffic Director  
		Intel(R) NetStructure(tm) 7170E Traffic Director-Export 
		Intel(R) NetStructure(tm) 7175 Traffic Director  
		Intel(R) NetStructure(tm) 7175E Traffic Director-Export 
		Intel(R) NetStructure(tm) 7180 e-Commerce Director  
		Intel(R) NetStructure(tm) 7180E e-Commerce Director-Export 
		Intel(R) NetStructure(tm) 7185 e-Commerce Director  
		Intel(R) NetStructure(tm) 7185E e-Commerce Director-Export   

Release Date:	05/21/01

Description:	This Service Release is an accumulation of fixes
		available for the Intel(R) NetStructure(tm) products
		listed above since the latest production release,
		version 2.7.0.0.76.  See the details below for
		descriptions of fixed issues.

Prerequisites:	This Service Release may be installed on a unit that is 
		booted to at least the following builds:
			2.3.1.0.16	7140/7140E/7170/7170E/7180/7180E
			2.4.1.0.7	7145/7145E/7175/7175E/7185/7185E

Fix Details:	CR003069: Corrected a problem that caused 
		ArrayIndexOutOfBoundsException messages to be logged.
		The statistics received for load balancing for
                Layer 7 services were not handled correctly in the
		Policy Manager.  See also CR003313 below.  Applies to
		Layer 7 services only.

		CR003136: Corrected a problem that caused services
		configured as "SAP" mode to be restored as "brokered".

		CR003137: Corrected a problem that caused services
		configured as "OPR" mode to be restored as "brokered".

		CR003139: Corrected a problem that caused a service
		configured as "Disabled" mode to be restored as
		"Enabled".

                CR003210: Introduces TCP/IP keepalive support into
		Layer 7 services for client connections.  Addresses
		sites with ESTABLISHED client connections that build
		up over time by allowing TCP/IP keepalive probes to
		identify and terminate idle connections.  Applies to
		Layer 7 services only.

		CR003238: Changed Layer 7 SSL services logging to 
		remove a log message when an HTTP request was received
		for an HTTPS service as a means of reducing resource
		usage during a possible Denial of Service attack.  
		Applies to Layer 7 services only.

		CR003245: Corrected a problem with the CLI command
		"config ssl cache" that allowed users to input invalid
		command options without errors.  Applies to Layer 7
		services only.

		CR003249: When deleting the client-ca certificate, the
		Certificate Revocation List (CRL) is also deleted
		automatically.  Deleting the client-ca certificate now
		also disables the CRL.  Applies Layer 7 services only.

		CR003255: The range for certificate life should be 1
		through 365.  Corrected a problem with the CLI display
		as "1 through 364".  The correct range of values is
		accepted as input.  Applies to Layer 7 services only.

                CR003264: Added additional verification of the Active
		Server List to Layer 7 services to resolve various
		problems due to apparent errors in the Policy Manager.
		Applies to Layer 7 services only.
                NOTE:  IRV must be disabled when using this feature.

		CR003266: Corrected a problem with the GUI Admin
		interface that accepted invalid values when defining
		a rich expression.  Applies to Layer 7 services only.

		CR003269: The online help for the "config cli username"
		command contained incorrect instructions for deleting a
		username.

		CR003270: A single rich expression was not deleted
		normally from the GUI Admin interface.  Applies to 
		Layer 7 services only.

		CR003275: Corrected a problem that did not allow a
		TCP/IP FIN packet to be forwarded to the server.
		Applies to Layer 7 services only.

		CR003313: Changed Layer 7 services to report the
		correct number of connections on a rebalance interval
		for use by Policy Manager in computing average response
		times.  Applies to Layer 7 services only.

                CR003314: If a server is configured with two or more
		Layer 7 expressions, the server status was not set
		correctly when the server was disabled and re-enabled.
		Applies to Layer 7 services only.

		CR003341: Corrected a problem with CPS statistics
		reporting that did not included data for connections
		when the server responded with a FIN in the initial
		data packet.

		CR003625: Corrected problems with Layer 7 services
		restarting when it is not necessary.

		CR004027: Corrected SNMP MIB typographical errors.
		New MIBs are available in the MIBS_2_8_2.zip file.
		The current 2.7.0 version MIBs will also work with
		this software version.

Installation Instructions:
1)  Download the image file to an ftp server. 

2)  Save the current policygroup configuration to a new file using the
	CLI or GUI:
		Example: # save myconfig  

3)  Install the image file using the CLI "config sys software install"
	command or the GUI Update Software facility.

4)  Verify the newly installed boot index is available for boot using the
	CLI "config sys software info" command or the GUI Update Software
	facility.

5)  Boot to the newly installed boot index using the CLI "config sys
	software boot" command or the GUI Update Software facility.

6)  Restore the policygroup configuration from the saved configuration
	file from step 2 above:
		Example: # restore myconfig